How to Clean Wicker Lounge Chair

Jul 7th

Wicker lounge chair can be a beautiful and practical addition to indoors or outdoors. Unfortunately, after years of wear, rattan furniture can show signs of aging. Wicker chairs can be brought back to life with a fresh coat of paint. In a few simple steps, anyone can revive old furniture indoors and outdoors by cleaning and repainting a tired chair.

Instructions

Cleaning a car seat for re-painting. Use a steel brush to scratch old paint away from any solid areas in the wheelchair. Vacuum wicker lounge chair to remove dirt and chipping paint. Damp the basket chair thoroughly with a damp sponge. Allow the chair to dry completely. Use a compressed air canister to blow any residual dust or dirt from cracks between rubbings.

Select an enamel spray paint to paint the wicker lounge chair. Hold spray paint 8 to 10 inches away from the wheelchair. Paint with broad, even Stokes. Cover the chair with a layer of paint and allow the chair to dry. Spray a chair with a second layer of paint. Allow the chair to dry for 48 hours before allowing anyone to sit in the chair.

Tips and warnings

If the wicker lounge chair is to be used outside, choose an enamel spray paint for outdoor use. Spray paint only in well-ventilated areas. Wicker is an attractive, long-lasting material that can be used indoors or outdoors for many years, with due care. Little preparation and you can recondition rattan furniture with color to make it suitable for outdoor use or to fit into a new indoor interior system.

Take your play outside and place it on the newspaper. Spray paint can slide, and then spread the paper well. Clean play with an old towel or clean cloth. Remove loose dirt and dust so that the color fits well. Prime the play with a spray primer if you do not use a surface spray paint classified for outdoor use. If you use a spray paint classified for outdoor wood / rattan, it is not necessary to use a primer if the play will be out in severe weather. Allow the primer to dry.

Shake the paint well until the ball moves freely for about one minute. Start painting the areas that require you to keep the jar at angles so that they do while the jar is full. Hold the can 12 to 16 inches from the surface and move the can all the time. Finish the spraying jigsaw piece. Make sure you use enough color to coat braided threads at all exposed places, while not using so much that color runs. Add accents with color or glaze if desired when the head fur dry. These can be stripes, geometric patterns or even more creative. Tape off your design with target tape and add accents with a brush, bathing the color for good coverage.